REASSEMBLY AND ADJUSTMENT
FUJI GW690-III (PROFESSIONAL) /FUJI GSW690-111 (PROFESSIONAL)
3-9 Installing the exterior parts
a.
After insuring that the shutter actuation counter assembly (7-93) operates correctly,
install the bottom cover (1-35) on the chassis with three screws (1-8) completely.
b.
Apply the shutter release (1-9) into the opening of the front left grip assembly (1-23)
and install the front left grip assembly (1-23) on the chassis with two screws (1-31).
c.
Fit the cylinder (1-42) to the synchrosocket assembly (7-37), and install the front right
grip assembly (1-36) on the chassis with two screws (1-43).
d.
Install the leather (1-11) on the recess of the front right grip with a piece of adhesive
tape (1-12). Next, install the rubber grip (1-10) on the recess of the front left grip with
adhesive.
Be careful not to allow adhesive to come out of the rubber grip.
e.
Apply adhesive slightly to three positions on the circumference of the focusing ring (I)
(7-63), and install the knurled ring (7-66) correctly without bending or tilting.
When all the above reassembling work ends, check each part and make sure that
the camera operates correctly and has a clean and neat appearance.
-
48
-