Table of Contents
Advertisement
REASSEMBLY AND ADJUSTMENT
FUJI GW690-III (PROFESSIONAL)/FUJI GSW690-111 (PROFESSIONAL)
3-8
Installing the top cover assembly (4-1) and adjusting the exposure counter
a.
Install the top cover assembly (4-1) temporarily, load the camera with a film, set the
film selector (3-3) to "4EXP", wind up the film advance lever, and make sure that the
exposure counter indicates."l". Now, depress the shutter release, and make sure that
the shutter is released and the exposure counter advances accordingly. Further, make
sure that the exposure counter no longer advances when the exposure counter indicates
"4".
b.
Next, reload the camera with a film, advance the film, and make sure that:
1)
The shutter cannot be released when the exposure counter is in between "S"
and "1".
2)
Hie shutter cannot be released when the exposure counter is in between "1" and
"2", "2" and "3", and "3" and "4".
[Hie shutter can be released only when the exposure counter indicates a certain
number after advancing the film one frame completely.]
Make the above check with the film selector set to "8EXP" and "16EXP" also.
c.
Remove the top cover assembly, remove one screw (1-4), and reinstall the screw after
applying the cord clamp (1-44).
Connect the black lead wire (3-38) to the cord clamp (3-39) and the contact (3-34) by
the use of a soldering iron.
Next, connect the red lead wire (3-36) to the contact (3-26) by the use of a soldering
iron.
Apply lug to the front right side of the screw (5-2), protect the lead wires with a tube,
and combine the lead wires the the cord clamp (3-39) to eliminate slackness.
d.
Thoroughly clean the lens of the range finder, viewfinder fame and other windows on
the top cover, blow out dust from the inside, and install the top cover assembly (3-1)
on the chassis with four screws (1-1).
e.
Place the shutter release shaft (1-20), stopper (1-19), film advance lever (1-18) and
spring washer (1-17) in their positions, and secure them with the shutter release
assembly (1-13).
When tightening the shutter release assembly (1-13), recommend a piece of thin
rubber sheet be used.
-
46
-
Advertisement
Table of Contents
