Table of Contents
Advertisement
REASSEMBLY AND ADJUSTMENT
FUJI GW690-III (PROFESSIONAL)/FUJI GSW690-111 (PROFESSIONAL)
3-2
Installing the film take-up mechanism assembly (4-1)
a.
Apply grease (FHA-064) to the teeth of the take-up gear (2-19), exposure counter
drive wheel (2-21), rack (4-47) and gear shaft (4-62) properly, and observing the condi¬
tions indicated below, fit them to the chassis. Next, secure them temporarily with four
screws (1-4).
1)
Leave the rack in its fully drawn out position. (Figure shows the rack not drawn
out.)
2)
The interlock pin (4-63) enters the groove of the lock lever (2-26).
3)
The exposure counter drive wheel (2-21), gear shaft (4-62), sleeve (4-26),
gear (4-33) and gear (2-19) are intermeshed.
-
32
-
Advertisement
Table of Contents
