Table of Contents
Advertisement
REASSEMBLY AND ADJUSTMENT
FUJI GW690-III (PROFESSIONAL) /FUJI GSW690-111 (PROFESSIONAL)
1-8 Assembling the front mask assembly (7-84)
a.
Apply the pin (7-100) of the release lever assembly (7-98) beneath the portion (K) of
the lever (7-110), and install the guide shaft (7-109) and guide shaft (7-106) repectively
to the upper and lower sides with the screw (7-107). Make sure that the release lever
assembly (7-98) operates by its own weight.
Apply the spring (7-108) to the pin (7-101) and guide shaft (7-109).
b.
Install the shutter actuation counter assembly (7-93) on the front mask assembly
(7-84) with two screws (7-90).
NOTE;
Be careful not to deform the claw (7-106).
Adjust the head of the claw (7-106) so that the ratchet wheel (7-96) advances one
tooth when the shutter release is depressed once and the last one digit of the exposure
counter advances one number when the shutter release is depressed ten times.
1-9 Combining the front mask assembly (7-84) with the helicoid assembly (7-62)
a.
Place the front mask assembly (7-84) on the helicoid assembly (7-62), apply the lead
wire through the hole (M) of the cover plate (7-219), and install the cover plate (7-219)
with four screws (7-97) together with the front mask assembly (7-84). Tighten the
screws securely. (Tightening torque: About 7kg-cm)
Install the interlock plate (7-73) on the male helicoid (7-67) with two screws (7-72).
b.
Pass the lead wire through the hole (m) of the light shielding mask (7-111), apply the
PCB (7-30) and lug (7-31), and tighten three screws (7-112).
Connect the lead wires to the PCB (7-30) by means of a soldering as shown in Fig. O.
Hold and arrange loose portion of the lead wire with lug .
c.
Install the moquette (7-213) to cover up the gap between the front mask assembly
(7-84) and light shielding mask (7-111) with adhesive. Now, insert the gear shaft
(7-124) into the hole of the gear (7-119) of the positioning plate assembly (7-113),
and install the positioning plate assembly (7-113) with two screws (7-120).
Connect the lead wire (7-216) to the PCB (7-30) and synchrocontact (7-39) by the use
of a soldering iron, and after passing the lead wire through the space between the front
mask assembly (7-84) and light shielding mask (7-111), secure the lead wire with a
piece of tape at the middle.
-
24
-
Advertisement
Table of Contents
