Table of Contents
Advertisement
REASSEMBLY AND ADJUSTMENT
FUJI GW690-III (PROFESSIONAL) /FUJI GSW690-III (PROFESSIONAL)
2-2
Assembling the exposure counter assembly
a.
Apply the gear (4-80) to the gear shaft (4-82) of the rotary plate assembly (4-77), and
secure it with the E-clip (4-85).
b.
Apply the spring (4-101) to two stopper pins (4-104), insert the rotary plate assembly
(4-77) in between the counter gear (4-97) of the dial assembly (4-93) and disc (4-99),
apply both of them to the shaft holder (4-102) and shaft (4-103), and push them into
the deepest position with the return lever (4-39) fully pushed in.
Thus, the rotary plate, lever assembly (4-88) and return lever (4-39) can be correctly
positioned. (See Fig. Y.)
c.
Wind up the spring (4-101) one turn, and secure the dial assembly (4-93) with the
screw (4-92).
Next, apply the gear assembly (4-60) to the shaft holder (4-102) from the bottom,
and install the gear (4-76) and nut (4-76). Now, lock the nut on the shaft with screw
locking agent.
Apply the smaller hook and larger hook of the spring (4-81) respectively to the hole on
the lever and guide shaft (4-44).
2-3
Combining the ratchet wheel assembly (4-67) with the film take-up gear train
a.
Apply the spring (4-5) to the pin (4-8) of the sleeve (4-7), and passing through the
inside of the column (4-24), apply the other end of the spring (4-5) to the guide shaft
(4-44).
b.
Place the base plate (4-3) in its position, turn the sleeve (4-7) toward the film taking up
direction, and tighten four screws (4-2) when the projection on the sleeve enters the
square portion of the base plate (4-3). (See Fig. Y.)
c.
Match the cut portion of the ratchet (for charging the shutter) with the square hole of
the arm (4-29) accurately (evenly), fit the gear (4-42) to the shaft (4-68) without
deviating the above matching, and after applying the washer (4-43) to the screw (4-40),
install the gear (442) with the screw (440). (See Fig. Z.)
d.
Install the dial (4-95) on the gear with two screws (4-94) and screw (4-109). Make sure
that each gear operates smoothly, each lever operates smoothly, each spring is installed
correctly, each lever is not deformed, and that each screw is tightened securely.
-
28
-
Advertisement
Table of Contents
