Roland BRIDGE CAST X Owner's Manual page 37

Menu Value
LOW CUT:
This cuts out unneeded low-band audio.
LOW CUT Off, On
Flat–500 Hz
NOISE SUPPRESSOR: This suppresses noises picked up from the surrounding environment by the mic.
NOISE SUPPRESSOR Off, On
TYPE Sets the noise suppressor type.
GATE
ADAPTIVE
LEVEL -96–0 dB
When GATE is
used
0–9
When ADAPTIVE
is used
COMPRESSOR:
Makes louder sounds quieter. This reduces the difference between the louder and softer sounds, making the
audio more listenable.
COMPRESSOR Off, On
THRESHOLD -48–0 dB
RATIO 1.00:1–Inf:1
ATTACK 0–100 ms
RELEASE 50–5000 ms
POST GAIN +0–+30 dB
DE-ESSER: Reduces sibilant noise (the sounds you hear when pronouncing "s" words and other hissing sounds).
DE-ESSER Off, On
1–10
EQ:
This is a 10-band equalizer, which lets you adjust the volume for each frequency band.
EQ Off, On
DETAIL Off, On
Gain (vertical sliders) -12–+12
Frequency Band 1 20–400Hz
(horizontal Bands 2– 20–470Hz
sliders) 4
Bands 5– 315Hz–3.3kHz
7
Bands 8, 3.0–20.0kHz
9
Band 10 800Hz–20.0kHz
Q 0.3–16.0
Explanation
Turns the low cut on/off.
Sets the frequency point from which the output is cut. The frequencies below
the frequency point you set are cut.
Switches the noise suppressor on/off.
Suppresses sounds that are lower in volume than the threshold. This helps
remove white noise and other such sounds during silence.
Analyzes the ambient sound to suppress unnecessary environmental noise.
Specifies the level used as the threshold for suppressing audio.
Set the level for suppressing noise. Larger values suppress more noise.
* If you hear unwanted changes in the sound when using the noise
suppressor, such as quieter audio or changes in sound quality, these issues
may be resolved if you increase the input gain for the mic.
Turns the compressor on/off.
Specifies the level used as the threshold at which the compressor is applied.
Reduces the level of sounds that exceed the level you specify here.
Sets the ratio at which the sound level is reduced, when it crosses the threshold.
For example, if you set "RATIO" to "2.00:1", audio levels that cross the threshold
are reduced by 1/2.
Sets how long it takes for the compressor to be applied.
* Times are approximate. This also changes depending on the volume.
Sets how long it takes for the compressor effect to be cancelled.
* Times are approximate. This also changes depending on the volume.
Adjusts the final output volume level after applying the compressor.
Turns the de-esser on/off.
Adjusts the intensity of the de-esser effect.
Turns the equalizer on/off.
When this is on, you can set the center frequency and the Q (the frequency
bandwidth).
Sets the amount of boost/cut for each frequency band.
Specifies the boost/cut center frequency for each frequency band.
* This setting is available when the "DETAIL" switch is enabled.
Adjusts the bandwidth used for boosting or attenuating each frequency band.
* This setting is available when the "DETAIL" switch is enabled.
Adjusting the Mic Audio
37