Snapper 1690769 Operator's Manual page 8

Mower Setup, Hitching & Unhitching
11. Make sure the lift bracket (A, figure 5) is installed
with hardware (B) as shown inserting capscrew
from inside. Use two 3/8-16 x 1 capscrews, 3/8
lockwashers and 3/8 nuts.
A. Lift Bracket B. Hardware
12. Using the rear holes in each footrest, install the
upstops (D, figure 6) as shown. See figure 7 to check
installation. Notice for tractors with agricultural
tires, different holes (B, figure 7) are used.
A. Capscrew, 5/16-18 x 1-1/2
B. Washer, 5/16
C. Washer, 13/32 x 1.5 (special)
D. Upstop
E. Washer, 5/16
F. Lockwasher, 5/1 6
G. Nut, 5/16-18
A. Upstop Bracket B. For Ag Tires
13. Attach the belt stop (H, figure 8) to the left-hand
mower bracket with fasteners shown.
A. Spacer
B. Capscrew, 7/16-14 x 3-3/4
C. Lockwasher, 7/16
D. Hitch, right-hand I Nut, 7/16-14
E. Nut, 5/16-18 j Hitch, left-hand
F. Lockwasher, 5/16 K Capscrew. 5/16-18 x 1
G. Washer, 5/16
H. Belt Stop
6