Table of Contents
Advertisement
4. If there are devices being paired or connected,
Name> to see the status of each device.
If there are no active Bluetooth devices being paired or connected, the display shows No devices.
5. Perform one of the following actions:
●
To clear the device from the list,
directly below Clr.
●
To exit from this function, press the Menu Select button directly below Back to return to the
previous screen without deleting the device name.
If Clr is selected, the display shows <Device Friendly Name> clear?.
6. Press the Menu Select button directly below Yes or No to proceed delete the device or to exit this
function and return to previous screen.
Result: If the device is deleted successfully, the display shows <Device Friendly Name> cleared to
indicate clearing is successful.
If the device is not deleted successfully, you hear the radio sounds a short, low-pitched tone. The display
shows <Device Friendly Name> clear failed. The display returns to previous screen.
Postrequisites:
NOTE: If Re-Pair Timer is set to infinite and you clear keys on the radio, you must clear keys on all
previously paired devices as well. (Please see your Accessories manual for further details.)
7.22
ASTRO 25 (P25) Programming Over Project 25
(POP25)
Also called Over-the-Air Programming, this feature allows configuration data and firmware to be upgraded
to your radio over-the-air. Full use of the radio is retained during the data transfer without interrupting
communication.
If the upgrade happens on the ASTRO 25 and ASTRO Conventional systems, the upgrade pauses to give
priorities to voice call, and continues after the voice call ended. If the upgrade happens on a Wi-Fi network,
the upgrade process runs concurrently with voice calls.
Once a configuration upgrade is downloaded to your radio, you can install new changes immediately, or delay
changes to be installed on the radio when it is being powered up.
Your radio can also be configured to allow you to accept or reject an upgrade.
7.22.1
Responding to the Notification of Upgrade
Procedure:
1. The display shows Upgrade? and two short, medium- pitched tones sound every 30 seconds until the
user makes a choice of either accepting, delaying, or rejecting the request.
NOTE: Do not remove the power cable or power down the radio during the firmware upgrade
process.
2. Perform one of the following actions:
●
Press the Menu Select button below Acpt to accept the request to upgrade immediately.
or
along the list of <Device Friendly
or
to the required device, press the Menu Select button
MN004863A01-AN
Chapter 7: Advanced Features
95
Advertisement
Table of Contents
