Motorola APX 1000i User Manual page 30

MN004863A01-AN
Chapter 4: Status Indicators
You Hear Tone Name
Long, Low- Time-Out Timer Timed
Pitched Out
Tone
Talk Prohibit/PTT Inhibit
Lack of Voice PTT Time
out
Out of Range
Invalid Mode
A Group of Busy
Low-Pitched
Tones
Short, Medi- Valid Key-Press
um-Pitched
Radio Self Test Pass
Tone
Clear Voice
Priority Channel Re-
ceived
Emergency Alarm/Call
Entry
Central Echo
Long, Medi- Volume Set
um-Pitched
Emergency Exit
Tone
A Group of Failsoft
Medium-
Automatic Call Back
Pitched
Keyfail
Tones
Console Acknowledge
Received Individual Call
Call Alert Sent
Site Trunking
Short, High- Low-Battery Chirp
Pitched
Tone (Chirp)
Two High- GPS Fails
Pitched
Tones
Ringing Fast Ringing
30
Heard
After time out.
(When PTT button is pressed) transmissions are not al-
lowed.
When the radio ends your call after it detected there is lack
of voice for 60 seconds after the PTT is pressed and hold.
Your radio ends the call to enable your radio to receive
calls from other radio users. The duration of this timer can
be preprogrammed by a qualified radio technician.
(When PTT button is pressed) the radio is out of range of
the system.
When radio is on an unpreprogrammed channel.
When system is busy.
When a correct key is pressed.
When radio passes its power-up self test.
At beginning of a non-coded communication.
When activity on a priority channel is received.
When entering the emergency state.
When central controller has received a request from a ra-
dio.
When volume is changed on a quiet channel.
When exiting the emergency state.
When the trunking system fails.
When voice channel is available from previous request.
When encryption key has been lost.
When status, emergency alarm, or reprogram request ACK
is received.
When Call Alert or Private Call is received.
When Call Alert is received by the target radio.
When a SmartZone trunking system fails.
When battery is below preset threshold value.
When the GPS fails or loses signal.
When system is searching for target of Private Call.