Table of Contents
Advertisement
Crestron MPS-250
Turn On the System
Turn Off the System
Lower the Projection Screen
Operations Guide – DOC. 6647A
Front Panel Lock Controls
Front Panel Lock:
On
•
Press the k or j buttons to toggle between On and Off. The current setting
is indicated with an asterisk (*).
•
Press ENTER to save the new setting and return to the Control Setup
menu.
Operation
Using the out-of-the-box functionality, the MPS-250 can be operated from the front
panel, an APAD, a 12-button keypad such as the CNX-B12 or the C2N-DB12, or the
C2N-FTB FlipTop Control Center.
Control from the Front Panel
The following describes operation of a system when using the out-of-the-box
functionality and the front panel. If a custom program has been created, the system
may function differently.
To turn on the system:
1.
Select an output by pressing any of the output buttons:
•
VIDEO for composite output on OUTPUT 1.
•
S-VIDEO for S-video output on OUTPUT 2.
•
YPrPb for component output on OUTPUT 3.
•
RGBHV for RGB video on OUTPUT 4.
•
TOUCHPANEL for local touchpanel on OUTPUT 5 (CH or QM).
2.
Select any of the source inputs by pressing an input button (BNC 1, BNC 2,
RGBHV 3, BNC 4, RGBHV 5, or QM IN 6).
To turn off the system, press the SYS PWR button twice.
NOTE: If the projector output was selected (output button 1), the display will
prompt the user to turn off the projector.
Press the function button labeled SCREEN DOWN to lower the projector screen.
NOTE: This function will only work if a projection screen's control lines have been
connected to RELAY 1 (up control) and RELAY 2 (down control).
Multimedia Presentation System 250
Multimedia Presentation System 250: MPS-250 • 75
Advertisement
Table of Contents
