All Devices - Crestron Multimedia Presentation System 250 MPS-250 Operation Manual

Crestron MPS-250
Upgrade Connected APADs
Operations Guide – DOC. 6647A
ID Devices Prompt
Press ENTER to ID
•
Press ENTER to continue the identification process, the MPS-250 will
clear all device settings and prompt the user to select the device type to be
identified.
Select Device Type
Select device type
APAD
•
Press the k or j buttons until the device type to be identified is displayed
on the LCD and press ENTER. The buttons (or SETUP LEDs) of the
selected device type will flash. Press a button (or the SETUP button) on the
selected device type to identify the device.
•
Repeat for all other device types that are connected to the MPS-250.
•
Press the MENU button to return to the menu.
NOTE: For information on using the front panel and input devices with the
MPS-250, refer to "Operation" on page 75.
NOTE: If a C2N-MNETGW has been identified, infiNET switches and dimmers
must still be identified with Crestron Toolbox. Refer to the respective infiNET
switch and dimmer manuals for more information.
APAD devices may need to be programmed to work with the MPS-250. If a
connected APAD does not display controls for the MPS-250, perform the following.
•
Access the Control Setup menu as described on page 65.
•
Press the k or j buttons until "APAD Upgrade" is displayed on the LCD
and press ENTER to display the APAD Upgrade controls.
Multimedia Presentation System 250

all devices.

Multimedia Presentation System 250: MPS-250 • 67