Table of Contents
Advertisement
Multimedia Presentation System 250
Set the Subnet Mask
60 • Multimedia Presentation System 250: MPS-250
Display the IP Address
[000]
•
Turn the volume control clockwise or counterclockwise to select a number
in the left-most section of the IP address. You can also press the k or j
buttons to select a number.
•
Press ENTER to move the cursor to the next section of the address. To
change a different section, press the soft button under the section to be
changed.
•
Repeat the previous two steps until the entire IP address is set.
•
To save the new address and return to the Network Setup menu, move the
cursor to the right-most section and press ENTER. To cancel the operation
and return to the Network Setup menu, press MENU.
The MPS-250 can be configured to use an IP Subnet Mask for TCP/IP
communications. To set the address of the IP Subnet Mask:
•
Access the Network Setup menu as described on page 59.
•
Press the k or j buttons until "Subnet Mask" is displayed on the LCD and
press ENTER to display the Subnet Mask controls. The current IP address
of the Subnet Mask will be displayed.
Display the IP Subnet Mask Address
[000]
•
Turn the volume control clockwise or counterclockwise to select a number.
You can also press the k or j buttons to select a number.
•
Press ENTER to move the cursor to the next section of the address. To
change a different section, press the soft button under the section to be
changed.
•
Repeat the previous two steps until the entire Subnet Mask IP address is set.
•
To save the new address and return to the Network Setup menu, move the
cursor to the right-most section and press ENTER. To cancel the operation
and return to the Network Setup menu, press MENU.
IP Address
000.
000.
Subnet Mask
000.
000.
Operations Guide – DOC. 6647A
Crestron MPS-250
000
000
Advertisement
Table of Contents
