Network And Poe Power - Rj45 - Bosch AVIOTEC 8000i IR User Manual

AVIOTEC 8000i IR
2.
ð
The camera can be supplied with a power supply in case of missing PoE feature of the
network or for redundancy reasons.
Connect an approved power supply unit with a rated supply voltage of 12-26 VDC/24 VAC
as follows:
1.
2.
3.
Caution!
The Low Voltage power supply unit must comply with EN/UL 60950. The power supply must
!
be a SELV-LPS unit or a SELV - Class 2 unit (Safety Extra Low Voltage - Limited Power
Source).
Notice!
i
Make sure to pull and hold the safety plunger when removing the camera.
4.5.1

Network and PoE power - RJ45

Connect the camera to a 10/100 Base-T network:
Bosch Sicherheitssysteme GmbH
Use STP Category 5e cable with RJ45 connectors (the camera network socket is Auto
MDIX compliant).
The LEDs beside the Ethernet connection indicate network connection (green lit) and
IP traffic (orange flashing).
Strip back 7 mm (0.28 in) of insulation on the power supply cable (must be 16-28 AWG,
UL 14-30 AWG).
Loosen the screws of the supplied 2-pole connector and insert the stripped wires, then
tighten the screws again.
Insert the 2-pole connector into the camera power socket.
5
4
6
3
7
1 10-pin I/O connector
3 Grommet (IP66 or IP67)
5 RJ45 network connector
7 Safety plunger
2 Safety wire anchor
4 Punch down network connector
6 Cable holder / grounding point for
punch down connector
8 PCBA camera connector
User manual
Installation | en
8
1
2
2023.10 | 02 | F.01U.414.168
27