Test And Operation - Gree GWH09AVCXB-K6DNA1B/I Owner's Manual

Replacement of batteries in
remote controller
reinstall
Press the back side of remote controller
1.
marked with " ", as shown in the fig, and then
push out the cover of battery box along the
arrow direction.
Replace two 7# (AAA 1.5V) dry batteries, and
2.
make sure the position of "+" polar and "-" polar
are correct.
Reinstall the cover of battery box.
3.
NOTICE
● During operation, poin t the remote control signal
sender at the receiving window on indoor unit.
●
The distance between signal sender and receiving
window should be no more than 8m, and there
should be no obstacles between them.
●
Signal may be interfered easily in the room where
there is fluorescent lamp or wireless t elephone;
remote controller should be close to indoor unit
during operation.
●
Replace new batteries of the same model when
replacement is required.
'
●
When you don t use remote controller for a long time,
please take out the batteries.
●
If the display on remote controller is fuzzy or there
no display, please replace batteries.
battery
remove
Cover of battery box

Test and operation

Check after installation
● Check according to the following requirement
after finishing installation.
Items to be checked
Has the unit been
installed firmly?
Have you done the refri-
gerant leakage test?
Is heat insulation of pipe-
line sufficient?
Is water drained well?
Is the voltage of power
supply according to the
voltage marked on the
nameplate?
Is electric wiring and pip-
eline installed correctly?
Is the unit grounded
securely?
Does the power cord fol-
low the specification?
Is there any obstruction in
the air inlet and outlet?
The dust and sundries
caused during installation
are removed?
The gas valve and liquid
valve of connection pipe
'
s
are open completely?
Is the inlet and outlet of
piping hole been covered?
Test operation
1. Preparation of test operation
● The client approves the air conditioner.
● Specify the important notes for air conditioner to
the client.
2. Method of test operation
● P t u h t o r u
the remote controller to start operation.
● Press MODE button to select AUTO, COOL, DRY ,
FAN and HEAT to check whether the operation is
normal or not.
● If the ambient temperature is lower than 16℃, the
air conditioner can't start cooling.
21
Possible malfunction
The unit may drop, shake or
emit noise.
It may cause insufficient
cooling(heating) capacity.
It may cause condensation
and water dripping.
It may cause condensation
and water dripping.
It may cause malfunction or
damage the parts.
It may cause malfunction or
damage the parts.
It may cause electric leakage.
It may cause malfunction or
damage the parts.
It may cause insufficient
cooling(heating) capacity.
It may cause malfunction or
damage the parts.
It may cause insufficient
cooling (heating) capacity.
It may cause insufficient
cooling (heating) capacity
or waste electricity.
g h h t e p o w e , r p e r s s " O / n O f " f b t u o t n o n