Table of Contents
Advertisement
9.8
Black Level
This parameter sets black level (clamp level for black signal).
Sets the black level at "BlackLevel [BlackLevelSelector]".
The lower limit of signal is clamped at this setting level. The signal does not lower than this.
(*) "AnalogAll" is only selectable at "BlackLevelSelector".
GenICam Parameters
BlackLevel
[BlackLevelSelector]
9.9
Blooming Reduction Mode
When using this mode, the blooming between pixels at pixel saturation, can be reduced.
It is necessary to set more than 6 dB at AnalogGain when using this function.
GenICam Parameter
BloomingReductionMode
9.10
ALC (Auto Light Control)
ALC has AGC (Auto Gain Control) and auto exposure function. It can be set individually.
The camera parameters adjust automatically based on current brightness of image, to achieve target brightness with
ALC function.
GenICam Parameters
AutoLightTarget
Target Brightness Formula (AutoLightTarget)
8bits output: Target Brightness (Gradient) ＝ AutoLightTarget
10bits output: Target Brightness (Gradient) ＝ AutoLightTarget × 4
12bits output: Target Brightness (Gradient) ＝ AutoLightTarget × 16
The brightness of image adjusts to achieve "AutoLightTarget" brightness with AGC and auto exposure function.
When AGC and auto exposure are enabled, at first, brightness adjusts with auto exposure function. If the
brightness does not achieve "AutoLightTarget" brightness with auto exposure function, brightness adjusts with
AGC function.
STC-LBS34U3V-SWIR
Product Specifications and User's Guide
IFloat Type
Black Level, Default: 8 (on 8bits output)
Range:
8bits output: 0 to 63
10bits output: 0 to 255 (10bits Packed outputs same as this mode)
12bits output: 0 to 1,023 (12bits Packed outputs same as this mode)
IEnumeration
Blooming reduction mode selection
Type
Selection: ON (On), OFF (Off)
Default: Off
IInteger Type
Target Brightness
Range: 0 to 255, Default: 127
No. 22S036-00
37/54
Advertisement
Table of Contents
