Table of Contents
Advertisement
PAGE
BASIC PROGRAMMING
8
PROGRAMMING
DIALING MODE
1
PRG
Press
.
2
Press
or
until "
displays.
"#"
3
Press
to toggle among the
settings.
4
When the desired setting is displayed,
OFF
PRG
press
or
to end the
programming session OR press
to advance to another
programming step.
NOTE:
Dialing Mode is a universal setting. When the
mode is changed on any handset or the base, the
setting is changed for the entire system.
(cont.)
PROGRAMMING
LINE IN USE DETECTION
(LIU DETECT)
The unit can be programmed to detect
whether the line is properly connected, and to
"
display when the line is being used. For most
users, this feature should be programmed to
"On". If you are connecting the unit to a PBX
system or if you live in an area prone to line
voltage irregularities, you may want to turn
this feature "Off".
When LIU is set to "On", line-in-use status
or
will be displayed as follows:
On handset – L1 icon will display when the
line is in use.
On base unit – Base LED will flash when the
line is in use.
To program Line In Use Detection:
1
PRG
Press
.
2
Press
or
until "
displays.
"#"
3
Press
to toggle between "On" and
"Off".
4
When the desired setting is displayed,
OFF
PRG
press
or
to end the
programming session OR press
to advance to another
programming step.
NOTE:
LIU Detect is a universal setting. When the mode
is changed on any handset, the setting is changed
for the entire system.
PRIVACY
The Privacy setting is only necessary if the
handset is used with a 2-Line multiple
handset system. This setting is not necessary
when using the system. Regardless of
whether Privacy is programmed to "On" or
"Off", the unit's operation will not be affected.
PROGRAMMING
THE RINGER LEVEL
Select between three volume levels for the
handset's ringer.
1
PRG
Press
.
Press
or
until "
2
displays.
"#"
3
Press
to toggle among the
settings Low/Mid/Hi.
"
4
When the desired setting is displayed,
OFF
PRG
press
or
programming session OR press
to advance to another
programming step.
or
RESETTING
THE HANDSET
At any time, you may reset a handset to return
to the factory default settings. Please note
that this action will completely restore the
handset to its factory programmed settings.
Resetting the handset will NOT reset the
universal settings or the stored information
(such as Caller ID records) contained in the
base unit.
1
PRG
Press
2
Press
or
displays.
PRG
Press
3
reset. You will hear a beep to confirm
"
that the reset process has been
initiated. The LCD will display:
4
After 15 seconds, the handset will
to end the
return to standby mode.
or
NOTE:
Make sure to set the Handset I.D. and Security
Code after resetting the handset. Each handset
has the same default Handset I.D. of station 11. If
more than one handset has the same Handset
I.D., the system will not function properly.
PAGE
9
.
until "
"
again to complete the
Advertisement
Table of Contents
