Table of Contents
Advertisement
PAGE
INITIAL SETUP
2
SELECTING A LOCATION FOR THE BASE UNIT
The base unit needs AC power and connection to a telephone jack. This location should be as
central as possible in your home or office.
SELECTING A LOCATION FOR ADDITIONAL HANDSETS
Anywhere you have power will do! Avoid high humidity or high heat areas, and keep the
handsets out of extended exposure to direct sunlight. Handsets can be swapped in their
chargers at any time and can be placed anywhere within the extended transmission range of the
base.
OPERATING DISTANCE/NOISE INTERFERENCE
For optimal performance, your phone's base unit should be installed as follows:
Away from electrical appliances
such as a microwave oven, TV,
personal computer, or another
cordless phone.
NOTE:
While using the handset:
If you are near a microwave oven which is being used, noise may be heard at the receiver.
Move away from the microwave oven and closer to the base unit.
If more than one cordless phone is being used and your handset is near another cordless
phone's base unit, noise may be heard. Move away from the other cordless phone's base unit
and closer to your base unit.
In a HIGH and CENTRAL location with
no obstructions nearby.
INSTALL THE BASE UNIT
Plug the line cord into the "TEL LINE"
1
jack on the back of the base unit and
the other end into your telephone wall
jack.
2
Connect the AC adapter to the back of
the base unit and plug into an electric
outlet.
INSTALL
THE HANDSET BATTERY
1
Slide open the battery compartment
cover and connect the NiMH battery
pack as shown in the illustration at
the right.
WARNING
To prevent fire or shock hazard, do not expose the set to rain or moisture.
To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only.
CAUTION
1. Use batteries only intended for recharging. Use only the following battery pack:
Nickel Metal Hydride, 3.6 volts, 700 mAh.
2. Do not dispose of the battery(ies) in a fire. The cell may explode. Check with local codes
for special disposal instructions.
3. Do not open or mutilate the battery(ies). Released electrolyte is corrosive and may cause
damage to the eyes or skin. It may be toxic if swallowed.
4. Exercise care when handling the battery(ies) in order not to short the battery(ies) with
conducting materials such as rings, bracelets, and keys. The battery or conductor may
overheat and cause burns.
CHARGING THE BATTERY
1
Place the handset in the charging
cradle. Additional handsets will
include their own individual
charging cradles. The battery will
fully charge after approximately
10-12 hours.
PAGE
3
Advertisement
Table of Contents
