Using Hold To Stay On A Selected Frequency - Uniden BCT-12 Operating Manual

Operating Instructions

Using HOLD to Stay on a Selected Frequency

When scanning stops on a desired frequency, you can lock onto
that frequency for as long as you like.
To monitor only one frequency:
1. When the scanner stops on
the desired frequency, press
H
the key. The LED
display now indicates the
mode you are monitoring.
The scanner remains on that
frequency until you cancel
the Hold mode by
H
pressing
2. To resume scanning and reactivate the Alert feature, press the
H
key.
If the BCT-12 stops on an undesired frequency, press the
twice to force the unit to start scanning again before the end of that
transmission.
BE CAREFUL!!When you are in the Hold mode, there will be no
REMEMBER!! When you apply power, the BCT-12 comes on
30
.
Alert tones or Warning light, even if you are on
the Alert frequency.
to exactly the same service and in exactly the
same mode as when last turned off. If you are
monitoring an Alert frequency in the Hold mode
when you turn the BCT-12 off, it will come back
to that Alert frequency in Hold mode when you
turn it back on. The Alert feature will be inactive.
To restore the Alert feature, press the
MUTE ALT HP
LP
W/A LP
HOLD
ALT HP
MUTE
HP
W/A LP
HOLD
H
H
key
key.