Uniden BCT-12 Operating Manual page 23

2. When the BCT-12 detects an
active frequency, it displays
NW in the LED display. The
BCT-12 will stop for two
seconds, and then resume
scanning with NW blinking in
the LED display.
Scanning Department of Transportation Frequencies
This mode scans the state road repair, snow clearing, and weigh
station crews of the state's Department of Transportation as well
as Highway Patrol channels. This mode is outstanding for driving
during hazardous or winter weather. Mobile extender and other
enforcement channels are priority checked for activity.
Note: The priority check can be turned off by pressing and
holding the Alert key for 1.5 seconds.
1. To scan DOT frequencies,
M
press the
until DT is blinking on the
LED display.
2. While scanning, the BCT-12
displays the state code for
the state you selected. When
the BCT-12 detects an active
frequency, it displays DT or
HP in the LED display. The
BCT-12 will stop for two
seconds, and then resume
scanning with the state code
displayed in the LED display.
key repeatedly
Operating Instructions
MUTE ALT
NW
W/A
HOLD
MUTE ALT
DT
W/A
HOLD
MUTE ALT
TX
W/A
HOLD
MUTE ALT
DT
W/A
HOLD
MUTE ALT
HP
W/A
HOLD
HP
LP
HP
LP
HP
LP
HP
LP
HP
LP
23