Rear Wall Cut-Out Without Drilling Template; Creating The Rear Wall Cut-Out With Surface-Mounted Installation And An In- Stallation Depth Of 23,8 Cm - Miele KMDA 7676 Operating And Installation Instructions

Installation

Rear wall cut-out without drilling template

Creating the rear wall cut-out with surface-mounted installation and an in-
stallation depth of 23,8 cm
Ideally, the drilling template supplied with the appliance should be used. The fol-
lowing instructions should only be used if the drilling template is not available.
View of the drilling template side 2. Not to scale.
 Measure the thickness of your worktop (C).
 Locate the centre of the long axis of the cut-out.
 Mark the point that is 177.5 mm (A) to the right of the midpoint.
 Mark the point (D) that is (B [161 mm] – C [thickness of the worktop]) below the
right end of distance A.
 Saw a hole with a diameter of 146–150 mm around this point.
 Plug&Play mode only: engage the Plug&Play adapter in position 2.
102