Miele KMDA 7676 Operating And Installation Instructions page 60

Adjusting settings
1
Programme
P:17 Vapour extraction operating
mode
P:18
Start settings of Con@ctivity
Number of vapour extraction
P:19
power levels
1
Programmes not shown here have no allocation.
2
The factory default setting is shown in bold.
3
After the hob has been switched on,  appears in the timer display for a few seconds.
4
The total output of the hob may be reduced in order to meet the local network provider's
requirements.
5
The settings for the
factory default settings.
6
In the text and tables, the extended power levels are shown with a dot after the number.
7
The confirmation tone of the On/Off sensor control cannot be switched off.
8
Plug&Play mode: Con@ctivity is required for correct operation.
9
Factory-set code:
KMDA 7676 FL-U
KMDA 7676 FL-A
10
The settings only take effect if Con@ctivity has been activated in the
60
10
P:17
operating mode of the vapour extraction will not be reset to the
C:00
:
C:01
:
2 Settings
Code
Recirculation mode
9
C:00
Extraction mode
9
C:01
C:00 Always start with Con@ctivity deac-
tivated
C:01 Always start with
Con@ctivity activated
Start with the most recently set
C:02
Con@ctivity state
3 power levels + Booster
C:00
C:01 9 power levels + Booster
P:16
programme.