Worktop cut-out for surface-mounted installation
B
ß R 4
10
B
Information for calculating the cut-out
The SmartLine appliances overlap the worktop by 10 mm.
When installing several SmartLine appliances, a distance of 2 mm must be
observed between the individual SmartLine appliances.
Calculating cut-out dimension B
1 appliance = width of the appliance minus 10 mm on the right, minus 10 mm on
the left.
Several SmartLine appliances = total width of the appliances plus 2 mm distance
between the SmartLine appliances, minus 10 mm on the right, minus 10 mm on
the left.
Some examples are illustrated below.
49