Table of Contents
Advertisement
Accessing programming mode
The hob is switched off.
Touch and hold the and sensor
controls until the + sensor control
lights up and appears in the timer
display.
After a few seconds : (Programme
01) will flash alternately with : (Code)
in the timer display.
Adjusting settings
Setting the programme
For a two-digit programme number you
need to first set the tens position.
While the programme is visible in the
display (e.g. :), press the + sensor
control repeatedly until the number
for the programme you want appears
in the display or touch the appropri-
ate number on the numerical display.
Setting the code
While the code is visible in the display
(e.g. :), press the + sensor control
repeatedly until the number for the
code you want appears in the display
or touch the appropriate number on
the numerical display.
Saving the settings
Whilst the programme is visible in the
display (e.g. :), touch the
sensor control until the displays
go out.
To avoid saving the settings
While the code is showing in the dis-
play (e.g. :) touch the sensor
until the indicators go out.
57
Advertisement
Table of Contents
