Installation - Rheem 953060DP Owner's Manual And Installation Instructions

THIS WATER HEATER IS FOR OUTDOOR INSTALLATION ONLY AND
SUBJECT TO AN ADEQUATE SUPPLY OF FRESH AIR.
THIS WATER HEATER IS NOT SUITABLE FOR POOL HEATING.
INSTALLATION STANDARDS
The water heater must be installed:
•
by a qualified person, and
•
in accordance with the installation instructions, and
•
in compliance with the Plumbing Code of Australia (PCA), Standards
AS/NZS 3500.4 and AS/NZS 3000, and all local codes and regulatory
authority requirements.
•
in New Zealand also conforming to Clauses G12 and H1 of the New Zealand
Building Code.
Warning: This water heater may deliver water at high temperature. Refer to
the Plumbing Code of Australia, local requirements and these installation
instructions to determine if additional delivery temperature control is required.
Refer to "Hot Water Delivery" on page 31.
All packaging materials must be removed from the water heater prior to its

installation.

WATER HEATER APPLICATION
This water heater is designed for the purpose of heating potable water. Its use in
an application other than this may shorten its life
If this water heater is to be used where an uninterrupted hot water supply is
necessary for the application or business, then there should be redundancy
within the hot water system design. This should ensure the continuity of hot water
supply in the event that this water heater was to become inoperable for any
reason. We recommend you provide advice to the system owner about their
needs and building backup redundancy into the hot water supply system.
Note: Australian Standard AS 3498 and New Zealand Building Code
Clause G12 require that a water heater provides the means to inhibit the growth
of Legionella bacteria in potable water. This water heater can satisfy these
AS 3498 and Clause G12 requirements provided it is energised and the
thermostat setting is 60°C or higher, including when it is used as an in-series
booster water heater for a solar water heater.
INSTALLATION
28