Advertisement
UIAGRAM
OF IHI::L, ur_uLL
Speed
Control
LED Track
Displays
incline Control
_LS
F _--_LS
SpE_I]
_IME
OIST_NC_
If there is a thin sheet of
clear plastic on the face
of the console, remove it.
BATTERY
INSTALLATION
The console requires two "AA"
batteries
(not in-
cluded). Alkaline batteries are recommended.
To in-
stall batteries, open the battery cover as shown below.
Press two batteries into the battery compartment,
with
the negative (-) ends of the batteries touching the
Cover Tab
springs. Close the battery cover, push up on the tab,
and then push the tab forward as shown. Be sure that
the tab locks into place.
STEP-BY-STEP
CONSOLE OPERATION
Before operating
the console, make sure that the
power cord is properly plugged in. (See HOW TO
PLUG IN THE POWER CORD on page 7.)
Next, step onto the foot rails of the treadmill.
Find the
clip attached
to the key (see the drawing
above),
and
slide the clip onto the waistband
of your clothing.
Test
the clip
by carefully
taking
a few
steps
backward
until
the
key
is pulled
from
the console.
If the key
is not pulled
from
the console,
adjust
the position
of the clip
as needed.
Follow
the steps
on page 9 to operate
the console.
Advertisement
