Advertisement
3.. Insert a Handrail (1) into the upper end of the right Upright
(11), with the lower end of the Handrail to the side of the
Upright as shown. Tighten a Handrail Screw (53) two
turns _to the Upright and the Handrail. Do not fully
tighten the Handrail
Screw yet.
3
4. Refer to drawing 4a. Slide a Handrail Cap (41) onto the
Handrail (1). Pull the lower end of the Handrail back
slightly--just
far enough to position the Handrail Cap on
the Upright (11) as shown in drawing 4b. Important:
Do
not pull the Handrail back too far--just
enough to po-
sition the Handrail Cap. Tighten a Cap Screw (87) with
a Washer (39) into the Handrail Cap and the Upright.
Tighten the Handrail Screw (53) used in step 3.
Attach the other Handrail (1) to the left Updght (not
shown) as described above.
5. Cut and remove the plastic tie holding the Wires (21).
Place the Console Base (46) on the right and left Uprights
(11) (only the right Upright is shown). Note: Make sure the
Upper Body Arms are behind the Console Base as shown
on page 4. Connect the two indicated Wires (21) to the
two connectors in the Console Base. Loosely thread four
Screws (33) Into the Uprights and the Console Base. After
all four Screws have been started, snugly tighten them.
Be careful not to overtighten the Screws,
Thread the Cable Tie (16) through the Clamp (61),
5
11,,
/ / •......
•
•Cable Tie. Pull the Cable Tie tight and cut off the end .......
6
6. Attach the Storage Latch (14) to the left Upright (11) with
two Screws (33). Be careful not to overtighten the
Screws.
ar0und the two Wires (21) and through the end on the
:
_
_:
i::
:,
7. Make sure that all parts are"tigllte_ned before you usethe treadmilL,Keep
the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet,
place a mat under the treadmill.
6
Advertisement
