Advertisement
TROUBLE-SHOOTING
Most treadmill problems can be solved by following the simple steps below. Find_the symptom that
applies, and follow the steps listed. If further assistance is needed, call our toll-free HELPLINE at
1-800-736-6879,
Monday through Saturday, 7 a.m. until 7 p.m. Central Time (excluding holidays).
1. SYMPTOM:
THE POWER DOES NOT TURN ON
a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged
into a properly grounded outlet (see page 7). Use only a single-outlet surge suppressor that is UL 1449 listed
as a transient voltage surge suppressor (TVSS). The surge suppressor must have a UL suppressed voltage
rating of 400 volts or less and a minimum surge dissipation of 450 joules. The surge suppressor must be
electrically rated for 120 volts AC and 15 amps. Important: The treadmill is not compatible with GFCI-
equipped outlets.
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.
c. Check the cimuit breaker located on the treadmill near the
power cord. If the switch protrudes as shown, the circuit
breaker has tripped. To reset the circuit breaker, wait for five
minutes and then press the switch back in.
2. SYMPTOM:
THE POWER TURNS OFF DURING USE
Tripped
Reset
a. Check the circuit breaker located on the treadmill frame near the power cord (see 1. c. above). If the circuit
breaker has tripped, wait for five minutes end then press the switch back in.
b. Make sure that the power cord is plugged in.
c. Remove the key from the console. Reinsert the key fully into the console.
d. If the treadmill stillwill not run, please call our toll-free HELPLINE.
3. SYMPTOM:
THE DISPLAYS OF THE CONSOLE DO NOT FUNCTION
PROPERLY
a. Check the batteries in the console. See BATTERY INSTALLATION on page 8. Most problems are the result
of drained batteries.
b. Remove the key from the console and ONPLuG THE PowER
CORD, Remove the two Resistance Bracket Bolts (81), Washers
(39), and Star Washers (90) from the ieft Updght (11). Set the
left upper body arm aside.
ii
is
I
Remove the key from the console and UNPLUG THE POWER
CORD. Remove the screws from the hood, and carefully remove
the hood. Locate the Reed Switch (44) and the Magnet (45) on
the left side of the Pulley (50). Turn the Pulley until the Magnet is
aligned with the Reed Switch. Make sure that the gap between
the Magnet and the Reed Switch is about 1/8". If necessary,
loosen the Screw (33) and move the Reed Switch slightly.
Ratighten the Screw. Re-attach the hood and then re-attach the
left upper body arm. Run the treadmill for a few minutes to check
• for a.corract_speed:reading.
....
Top
View
12
Advertisement
