Advertisement
Ep eee
Sco
A Eis ota s
i i eee eee cera
|
t
Pa
ee RE ee Fee
Before you use this VTR, it is necessary to connect it to your TV.
AERIAL IN
Information
te
The VTR signals are sent to your TV from the
AERIAL OUTPUT..socket...Your.television must
have a channel set aside exclusively for these VTR
signals.. This is called the video channel.
Preparation
Set the VTR/TV
selector to "VTR'.
Turn on the TV.
Select a free channel on the TV which you wish
to use for your video picture, for example
channel 9.
This channel 9 will be only used for watching a
video picture.
'Press the ON/STANDBY button to turn on the
VTR.
ON/STANDBY
Hold down the OSP button for more than 5 -
seconds.
VTR display
VIDEO
Tune the TV (on channel 9 for exampie in step 2)
so that the following screen is shown clearly.
(For tuning the TV, refer to the TV's manual.)
TV screen
CH MEMORY
GUIDE CH SET
ANTENNA SELECT
(MIX)
SATELLITE SETTING
SATELLI TE- INPUT ( SAT )
SAT. BRAND NO.
( 17 )
SeT=—-8
END=6Ea)
LA)
a
6
7
| Connection to Your TV (Without the AUDIO/VIDEO SCART Socket)
lf you use this connection, you must perform "Setting the Video Channel!" below.
lf after tuning (in step 5), you still have some
interference because of neighbouring broadcast
channels, press.the SHIFT. button.to. select
another video channel between channels 50
and 67.
&)
SHIFT.
&
Re-tune the TV to around UHF channel 62 (for
example), and confirm the screen is shown
clearly.
Press the OSP button.
Video channel setting is complete.
M@ Note on the antenna output
On the screen in step 5, the antenna output can
be set to "MIX" or "SW".
(Applied when the VTR is connected to your TV
only via the AERIAL OUTPUT socket.)
Press number button 3 to select "MIX" or "SW".
CH MEMORY
GUIDE CH SET
ANTENNA
SELECT
(MIX)
SATELLITE
SETTING
SATELLITE
INPUT ( SAT )
SAT. BRAND NO.
(
17 )
SET=H-8
END=@Eia
: You can watch a video picture on the video
channel regardless of whether or not you
have pressed the TV/VIDEO button.
The switch should only be set to "SW" if the
video pictures or TV pictures cannot be
obtained clearly.
: You can watch a video picture on the video
channel only when the "VIDEO" indicator is
lit in the VTR display by pressing the
TV/VIDEO button.
Advertisement
