Advertisement
et even OnE
STORING STATIONS ON THE VTR
To watch and record TV programmes via the VTR, it is necessary to store each TV station in the memory of the VTR.
This VTR can store up to 48 positions for TV stations.
| Station Storing Procedure
Apes Information
Each TV station operate in the U. kK, (e.g. BBCI,
ITV) broadcasts on a unique frequency, which in turn
has. been allocated a transmission channel number
(21 — 69). However, this unique frequency and
corresponding number changes for each TV station:
from area to area. For example, BBC1 in London
scuses channel number 26, while in Oxford BBC1-uses
channel number 57 (i.e., CH57).
This VTR will indicate these channel numbers (1 — 9,
21 — 69) during tuning.
Preparation
e Select the video channel or video input mode on
the TV.
* Set the VTR/TV
selector to "VTR".
¢ Turn on the VTR.
° If you use a Satellite receiver, make the
connection correctly (page 10) and-turn it on.
To store BBC1 to position number 1 -
on your VTR.
Allocation of the TV stations into the memory of
the VTR is expected to be as follows, for Video
Plus+ recording.
BBC1:
Position number 1
BBC2:
Position number 2
ITV:
Position number 3
«CHANNEL 4: Position number 4
Satellite:
Position.number.6,.example {if
connected by an RF lead only as.
shown below.)
Satellite
antenna
AERIAL
£x. RF output channel 38 §
INPUT
a
Satellite
RF OUT §
receiver
@
In-this case, select position number 6 in
step 4; and channel 38 in step 5 if the
output channel of your satellite receiver is
38, for example. Make sure that TV
receives a satellite broadcast.
Whenever you watch or record a satellite
programme, select position number 6.
important
This procedure can be performed only when the
3
VTR display shows a position number on the VTR.
If the "L1", "L2" or "SA" is displayed, press the
INPUT SELECT button so that the position
number appears.
Position number
} | _ Pressthe OSP. button.
re 2 Press number button 5.
MENU
osp
AUTO
SET UP
CH PRESET
SELECT= IF
_ | BCH: MEMORY.
@ GUIDE CH SET
BL ANTENNA SELECT
(MIX)
@ SATELEITE SETTING
SATELLITE
INPUT ( SAT )
SAT. BRAND NO.
( 17 )
SET =i1--
END+6Sa
Press number button 1toselect"CH
s s
MEMORY".
|
The VTR is-now:in the tuning mode, and the
screen display disappears.
VTR display
Example
@)
LI
= a r
lp
L
cri
Position
TV channel number
number
(any No. of 1-9, 21 — 69)
Press the CH/TRK button to select position
20]
number Ts
Press and hold the SHIFT button to start
22 |
searching for BBC1.
E
Higher numbered channel
Lower numbered channel
If the received TV signal is not BBC1, press and
|
hold the SHIFT button again.
f
If a clear. picture does not appear on the TV
Ea
screen after.searching is finished, make fine
pee
adjustment:with the INDEX buttons.
If the picture is
If the stripes
monochrome
Best picture
appear
"a
"Ty
<<
=
S|
Advertisement
