Advertisement
'HS Before the VTR enters the timer standby mode
a
paefeh
dac oeB
d t
(© indicator not lit). .
ae
First press the two TIMER buttons to release the timer
Ej
standby mode, and then press the ON/STANDBY
1)
Press the OSP button to.display the MENU
button to turn on the VTR. The VTR will be available
screen.
for use.
a
;
.
.
;
e
Be sure to press the two TIMER buttons again to
Pa
2)
Press number button 4.to select "PROGRAM".
Eg
return the VTR to the timer standby mode. after you
operate.
}
14:30
25.
8.°95 FR
i
'CH DATE
ON
OFF $0
1 OWE8O 21:30-22:00%
If a power failure occurs during, the timer programme
fox
fon
| {co
fro
|]
recordin
:
:
e Ifthe ro) indicator is missing in the VTR display after the
H
SELECT=—-§)
4
i
END-(6Sa
power failure, the programmed contents have been
cleared.
Reset the timer programming.
i
e When power has failed for a short time, the colon of the
i
Check the programmed data.
current time display blinks. The programmed:contents are
not affected.
Reset the clock.
3) Press
the OSP button twice to exit.
dl
"4
\
a During the:timer programme recording.
Error Indicators
( © indicator lit)
When the "FULL (CLEAR PROG?)" message appears on the
i
TV during programming, no more programmes can be —
Press.the OSP button.
;
El
entered. If you want to add another programme, select one
The screen for confirming appears.
existing programme on the screen by using number.buttons,
and press the CANCEL button to delete it.
14:30
25.
8.' 95°FR
:
CH DATE
ON
OFF $0
;
lf impossible PiusCode is entered, "INVALID CODE
1 GSO, 24: 30-22: 00%
ENTERED" blinks on the screen to tell you that the recording
cannot be performed. Press the CANCEL button to clear the
PlusCode and enter correct one.
OsP
io
fon}
foo
[rol
—j
END-@S2
if "CLASH" message appears on the screen during |
programming, it tells you that two programmes with the same
;
'
i
:
recording start time have been entered. You have to make a.
to
After about 30 seconds, the screen disappears.
correction. On this screen, blinking item number means that
"the iter "has been entered later.
ic
aaa
1) Enter the number of the programme you want to correct
using number buttons.
RECOR
2) Correct the timer programme data, or clear the data by
pressing the CANCEL button and then press the
VIDEOPLUS+ button to enter the PlusCode.
1) Ifthe @ indicator is lit, press the two TIMER
buttons to turn it off, and turn on the VTR by
pressing the ON/STANDBY.
_—k
%
Xq
2)
press the OSP button to display the MENU
screen.
. Overlaps the programmes
{f two programmes overlap, the recording start time of -
programme 2 has a priority over the recording end time of.
3) Press number button 4 to select "PROGRAM".
programme 1.
Ga
&
Overlapped.portion
4)
Select a program number which you want to
(Start time)
5)
Press the CANCEL buiton.
24
|
The line is cleared out.
iS
6)
Press the OSP button.
|
oo
34
Advertisement
