Custom 1/4'' Thick Door Panel Insert - U-Line Origins 1175BEVS00 Installation Manual

Side-By-Side Installation
Instructions
For a complete refreshment center, install two of the
following 1175 series units side by side: 1175R, 1175WC or
a 1175 BEV Center. Note that each Side-By-Side
Installation will be different.
• Cut-out width for a side-by-side installation is the total
of the widths listed under Cut-Out Dimensions in each
unit's Installation Guide.
For example:
Placing a 1175R next to another 1175 series unit would
require a cut-out width of:
24-3/16" + 24-3/16" = 48-3/8"
• No trim kit is required. However, 1/4-inch space needs to
be maintained between the units to ensure
unobstructed door swing.
• Units must operate from separate, properly grounded
electrical receptacles placed according to each unit's
Electrical Specifications.
Typical Side-By-Side Cut-Out
34-1/4"
to
35-1/8"
1/4" Space
Between
Appliances
Figure 11
www.U-LineService.com
1175R, 1175WC and 1175BEV Models
23-7/16"
7"
4"
8
4 Prepare/Install Door Panel or
Prepare Racks
Three types of custom treatments may be involved in your
installation:
• Black and White 1175R Refrigerators will accept a
Custom 1/4" Thick Insert to harmonize with or accent
the surrounding decor.
• 1175WC & 1175BEV Beverage Centers are equipped
with maple-trimmed wine racks that are coated at the
factory with a clear vinyl sealer, which will adequately
protect the wood in normal usage. A final finish coat
was not applied so that the wood trim could be stained
to match décor. The trim on the racks may be coated
with a final finish or stained.
If none of these treatments are to be included in this
installation, go on to 5 Adjust Door.

Custom 1/4'' Thick Door Panel Insert

Door Panel Preparation
A custom door panel can be inserted into the doorframe.
Custom door panels can be flat or raised, as long as the
maximum panel thickness where inserted into the door
reveal (channel) is 1/4"-thick. For raised panels, the depth
of the reveal is 1/4" on all four sides.
IMPORTANT
Raised panels will reduce the door's 90° swing/zero
clearance if the unit is installed next to a wall or similar
type of structure.
Cut the panel insert to the following dimensions.
Custom 1/4" Dimensions for 1175 Black & White units:
Width: 22-15/16"
Height: 26-15/16"
Custom 1/4" Dimensions for 1115 Black units:
Width: 13-15/16"
Height: 26-15/16"
The door panel must not weigh more than 20 lbs.
Door Panel Installation
Install the insert as follows:
CAUTION
Use care when handling the insert. Insert edges may be
sharp.
1. Remove top hinge screw pin with Phillips head
screwdriver. Remove door by tilting forward and lifting
off bottom hinge pin.
06/2006