1115R and 1115WC Models 2 Inspect and Plan You have received a carton containing your 1115R Refrigerator or 1115WC Wine Captain inside containing a Use and Care Guide and a Product Registration Card. Complete and mail the Product Registration Card or register online at www.U-LineService.com.
1115R and 1115WC Models 3 Prepare Site Your U-Line product has been designed for either free- standing or built-in installation. When built-in, your unit does not require additional air space for top, sides or rear. However, the front grille must NOT be obstructed and clearance is required for electrical connection in the rear.
1115R and 1115WC Models Door Swing/Clearances Information Black 1115R units have a zero clearance for the door to open 90° (see Figure 3). U-line recommends a minimum 23-11/16" clearance of 1/4” for black units and 2” for Stainless units Including...
Reversing the Door (1115R & 1115WC Black Units Only). Black Model 1115R To reverse the door, perform the following: 1. Remove the grille and grille cap (two screws). Figure 4 2. Remove top hinge from cabinet (three screws) (Figure 4). Hold door to keep it from falling. 3.
ULIN_0142_A 60 Hz, 15A circuit (normal household current). See Electrical Specifications on Page 10. Environmental Requirements Many U-Line models are designed to operate in harsh outdoor/marine environments. Special considerations include the following: (1115R REFRIGERATOR requirements) • The units are designed to operate between 50°F (10°C) and 110°F (40°C).
If none of these treatments are to be included in this installation, go on to 5 Adjust Door. Custom 1/4'' Thick Door Panel Insert (1115R Refrigerator Units Only) Door Panel Preparation A custom door panel can be inserted into the doorframe.
Page 9
Wood Trim Finishing The U-Line Wine Captain trimmed wine racks that are coated at the factory with a clear vinyl sealer, which will adequately protect the wood in normal usage.
Page 10
If staining the trim is desired, it must be done before the application of any type of final finish. Review the following staining/final finish and final finish-only guidelines when staining and/or sealing the wood to ensure proper adhesion and durability of the finish. Note: Glass in door is tinted.
5 Adjust Door Checking Door Alignment The unit’s door is aligned at the factory before shipment. However, its alignment could have been disturbed during shipment or during door panel installation. IMPORTANT Properly aligned, the door's gasket should be firmly in contact with the cabinet all the way around the door (no gaps).
Make any necessary adjustments. The unit’s top surface should be approximately 1/8" below the countertop. Glass Shelf Installation (1115R Refrigerator Only) 1. Carefully remove the glass shelves from the packaging. 2. Slide the shelves onto lower sets of ribs,...
See the Use and Care Guide’s Troubleshooting Guide for more solutions. For more than four decades, U-Line has distinguished itself as the leader in built-in undercounter ice making, refrigeration and wine storage appliances. U-Line Corporation, located in Milwaukee, WI, is a family operated manufacturer of built-in undercounter icemakers, Combo refrigerators, refrigerated drawers and refrigerator/freezers.