Leveling Information; Installation Tip; Installation Of The 1175R/1175Wc/1175Bev; Glass Shelf Installation - U-Line Origins 1175BEVS00 Installation Manual

7 Level the Unit

Leveling Information

Note: It is recommended that the unit is level.
1. Use a level to
check the levelness
of the unit from
front to back and
from side to side.
Level should be
placed along top
edge and side
edge as shown (see
Figure 18).
1
Figure 18
2. If the unit is not level, adjust the feet on the corners of
the unit as necessary (see Figure 19).
Figure 19
3. Check the levelness after each adjustment and repeat
the previous steps until the unit is level. Go on to
8 Install the Unit.

Installation Tip

If the room floor is higher than the floor in the cut-out
opening, adjust the rear feet to achieve a total unit rear
height of 1/8" less than the opening's rear height. Shorten
the unit height in the front by adjusting the front feet.
This allows the unit to be gently tipped into the opening.
Readjust the front feet to level the unit after it is correctly
positioned in the opening.
www.U-LineService.com
1175R, 1175WC and 1175BEV Models
ULIN_0041_A
Turn Foot to Adjust
8 Install the Unit
Installation of the 1175R/1175WC/
1. Plug in the power cord.
2. Gently push the unit into position. Be careful not to
entangle the electrical cord.
3. Re-check the leveling, from front to back and side to
side. Make any necessary adjustments. The unit's top
surface should be approximately 1/8" below the
countertop.

Glass Shelf Installation

(1175R Refrigerator and 1175BEV Beverage Centers )
1. Carefully remove the glass shelves from the packaging.
2. Slide the shelves onto lower sets of ribs, making sure
the decorative graphics are on the underside of the
shelves. Figure 20.
Figure 20
12
1175BEV
06/2006