Table of Contents
Advertisement
DMT-Svl Owner's Manual (Locate function)
Setting the Auto Return Start/End point
There are two ways to set the Auto Return Start point and End point: one is to hold
and store a desired time value in real-time during playback or while the DMT-8VL
is stopped: the other is to edit and store a desired time.
Storing the Start/End point In reeMIme
I
1
While the DMT-Bvl
ia
playing beck or stopped, press the HOLD/> key at the
location you wish to store as a Start point.
The time value obtained when you press the HOLD/> key will be held, and the
DStTSvL will enter edit mode.
_
_ _
r• The display RsaoMkxi mode setting is avatat* when BARBEAT/CLK is used for
I
I the Time Base Refer to pege *132" for details.
2 Press the STORE key. fThe STORE LED w* light up.)
3
Press the AUTO RTN START key.
The time value you held will be stored as a Starr point, and the display will go
back to the previous screen that was obtained before the time value was hold.
(The STORE LED will go off.)
4
.
Press the HOLD/> key again at the location you wish to store as an End point.
5. Press the STORE key. (The STORE LED will light up.)
6
Prees the AUTO RTN END key.
The time value you held will be stored as an End point, and the display will go
back to the previous screen that was obtained before the time value was held.
• In Heps 1 and 4 described above, you can press the STORE key Instead cH (ho
HOLD-* key. *er press the AUTO RTN START/AUTO RTN END key to set the
data more qwddy
1
89
Advertisement
Table of Contents
