Table of Contents
Advertisement
DMT
-8vl
Owner's Manual (Names and Functions)
6. SETUP
Refer to "2. Switching the display using the D1SP SEL key."
7. CHASE
This message flashes when the "Slave mode" in the setup mode is set to "ON." It will
light up when the lock operation Is complete.
B. CANT UNDO
If you try to perform Auto Punch In/Out recording after the DMT-Bvl enters Auto
Punch In/Oul mode, this message appears to warn you that you will he unable to
undo the recording even If you can record, because there Is not enough Undo area
on the disk.
». COMPLETED!
This message indicates that an operation such as copy, move, and paste has been
completed.
10. SURE?
This message is shown to confirm whether or not you wish to execute a certain
operation.
11. LOAD, SAVE, FORMAT, MTC OFFSET. FRAME RATE, MIDI SYNC OUT, TEMPO. BAR,
When the DMT-8vi enters Setup mode, the preceding words appear as names for
the parameters being set.
12. MKN
This Indication lights up when the DMT-8vl receives effective MIDI messages from
an external MIDI device.
13. DIGITAL
This indication lights up when the DMT-8vl is receiving a digital signal properly at
the DATA IN connector while loading data from a DAT machine. If this indication
is
blinking, the digital signal Is not being received correctly,
14. 7-atgmant Otsptoy
This display shows the ABS time. MTC time, BAR/BEAT/CLK, and Program number.
3. Switching the display using the DISP SEL key.
Let's assume that you turned ofT the power while the time display was using a time
base of "ABS," and then you turned the power on again. The DMT-8vi time display
will again use a time base of "ABS." (UnderlinesDisplayed program number)
At this time if you press the DLSP SEL key, the Disk Remain display (available
recording time on the recorder) will appear.
28
Advertisement
Table of Contents
