Erased Cut - Fostex DMT-8VL Owner's Manual

DMT-8VL Owner's Manual (Edit function)
3. Erase & Cut
The Erase function and Cut function are two different function, and are defined
as follows on the DMT-8vl. Make sure that you understand the difference before
using these functions.
<Note>
The Cut/E rase function e effective only lor the currency selected Program
Erase:
The function deletes (creates silence) only a speefied area (between the Auto Punch In and
Auto Punch Out points) of any track on the hard disk. Refer to the diagram below
You cannot erase data on all tracks aim dtaneoualy. (To erase data, 'ready' up to seven tracks
using the RECORD TRACK select keys) Refer to the following note for information on erasing
all tracks data.
«UIO FINCH Npc«* N/T0 PUNCH OUT PPPI
Any track
<Note>
The Cut function erases data from al tracks simultaneously (deacrfced laterj To
erase data from all tracks, drwde the tracks into two groups and apply the Erase
function to each group. (For example, first erase Tracks 1-4, then erase Tracks 5-
Cut:
This function deletes data starting from a certain poert (Auto Punch In pont) on the hard disk.
You need lo set all the tracks RECORD TRACK select keys 10 "READY' Only the start point
is needed Rater to the following dwgram
AUTO PUNCH N paw
104