Table of Contents
Advertisement
DMT-8vl Owner's Manual (Introduction)
*
To prevent possible electric shock and damage to the DMT-Svl, do not
remove the main unit cover or reach the inside the unit.
*
Do not let water or other liquid, or metal objects such as pins,
accidentally enter the inside of the unit because this may lead to electric
shock or damage. Should water enter the inside of the unit, remove the
power plug from the AC outlet, and consult your dealer or the nearest
FOSTEX service station.
*
To prevent damage to the DMT-Svl, be sure to power on the connected
devices first, then turn on the power to the DMT-8VL.
When you remove or connect the cables to the input/output connectors
on the DMT-8VI, make sure that the channel INPUT faders and volume
controls are set to "0."
Notes on handling the hard disk
*
The DMT-8vi is equipped with a high-precision hard disk. Do not expose
the unit to excessive vibration at any time. In particular, do not move
the unit or allow an impact to the unit when the power is on.
* Bfilore-lurning the power
first auitEetup
mode and make sure that the recorder scctlon is stopped.
Especially, never attempt to turn off the power to the unit
while the hard disk Is accessing dau (the HD .ACCESS LED is
lit or flashing). Otherwise, hot only will you lose recorded
data, but you may damage to the unit.
FOSTEX is not responsible for data lost during operation of
the unit.
*
Before you change the location of the DMT-8vl, pack the unit in the
shipping carton or an impact-resistant case.
Make sure that the unit is kept free from external vibration or impact
since the unit is very sensitive to vibration.
• U you wish to replace the included hart dts* w4h another harddisk. refer to
ftofor*
operating the DMT
-flw.'
on page '41. '
Notes on the setup location
*
Do not Install the unit in locations subject to the following:
* Extremely high or low temperature, or significant changes in
temperature
* Excessive humidity or dust
* Excessive changes in power supply voltage
* Unstable or significantly vibrating or shaking surfaces
* Near a strong magnetic field (such as a TV or speakers)
*
If you move the unit from a place with an excessively low temperature
to a warm place, or if you use the unit in a room in which the temperature
varies significantly during winter, condensation may occur on the hard
disk or other pans. In such cases, leave the unit for about an hour in
the new location before you turn on the power.
7
Advertisement
Table of Contents
