Table of Contents
Advertisement
DMT-8VL Owner's Manual (Names and Functions)
<Front panel (I/O connections)>
1
_cm_cm_cm i_
1
cm_
_i
45
46
45. Input lack [INPUT 1*5] (Connector: PHONE Jack)
Connect your sound source, such as musical Instruments and/or microphones, to
these Inputs. Connect the microphone to INPlTTs 1-2. These Inputs are equipped
with the LEVEL switch that allows you to switch the input level according to the
output level of the connected microphone.
46. Headphones connector (Connector: Stereo PHONE Jack)
Connect the headphones to this Jack. You can control the headphones volume using
the MASTER knob in the monitor section.
<Rear panel (I/O connections)>
47 48
49
50
1
_L _L _L
57
56
55 54 53
52
51
47. Storvo Out L. R lacks [STEREO OUT L.R) (Conrwctor: RCA pin |ack)
Connect the INPUT jack of the master recorder here.
These Jacks output the stereo bus L R signal. Use the master faders L/R to adjust
the output level.
48. Monitor Out Jacks [MON OUT L, R] (Connector: PHONE Jack)
Connect monitoring amplifier and speakers, or powered speakers here. These jacks
output the signal selected via the SELECTOR switch in the monitor section, that is,
the stereo bus L R signal or the monitor bus L, R signal. Use the MASTER knob in
the monitor section to adjust the output level.
49. AUX Sand 1, 2 Jacks [AUX SEND 1.2] (Connector: PHONE Jack)
Connect these jacks to the INPUT Jacks on the effect unit.
The signal selected and level-adjusted by the AUX Sendl knob or AUX Send2 knob
will be sent to the effect unit.
50. AUX Return 1,2 Jacks [AUX RTN 1,2. L/MONO, R) (Connector: PHONE Jack)
Connect these Jacks to the OUTPUT jacks on the effect unit. These Jacks can be also
used as auxiliary inputs. If the effect unit has MONO output, use the L/MONO Jack.
The Jack R will receive the same signal. Use the AUX RTN knobs 1, 2 to adjust the
input level.
25
Advertisement
Table of Contents
