Gateway E-1400 System Manual page 95

Probable Cause
The CRT may be old.
The color monitor displays everything in black and white.
Probable Cause
The system was turned
on before the monitor.
The display type is set
incorrectly.
The displayed characters are garbled.
Probable Cause
The video cable is
damaged.
The video card has
failed.
The display setup is
incorrect.
The video is distorted.
Probable Cause
The monitor's controls
are not properly
adjusted.
The connector or cable
is damaged.
The surge protector or
UPS is damaged.
84
Troubleshooting
Solution
Replace the monitor.
Solution
Make certain the monitor is turned on, and
then restart the system.
From the Control Panel window (Start |
Settings | Control Panel), double-click Display,
set the display to the appropriate monitor
type, and then reboot the system.
Solution
Check the cable and connectors for bent pins
or broken wires.
Try another video card.
From the Control Panel window (Start |
Settings | Control Panel), double-click Display
and check the settings. The correct video type
should be selected, along with a supported
resolution. Check your monitor and video
controller documentation for details.
Solution
Adjust the monitor controls until the text
becomes clear. (See your monitor
documentation for more information.)
Check the connector and cable for bent or
damaged pins.
Disconnect the monitor power cable and
connect it directly to the power source.