Fisher & Paykel 11 Series Installation Manual
Combination steam oven
Hide thumbs
Also See for 11 Series:
- Installation manual (30 pages) ,
- Installation manual (14 pages) ,
- User manual (60 pages)
Related Manuals for Fisher & Paykel 11 Series
Summary of Contents for Fisher & Paykel 11 Series
- Page 1 COMBINATION STEAM OVEN MINIMAL OS60SMTDB1, OS60SMTDG1 CONTEMPORARY OS60SDTDX2, OS60SDLX1 INSTALLATION GUIDE BI EU...
- Page 2 SAFETY AND WARNINGS READ AND SAVE THIS GUIDE WARNING! Electric Shock Hazard WARNING! To avoid hazard, follow these instructions carefully before installing or using this appliance. Failure to follow this advice may result in electric shock or death. Please make this information available to the person installing the appliance—doing so could reduce your installation costs.
-
Page 3: Before Installation
INSTALLATION CONSIDERATIONS BEFORE INSTALLATION AFTER INSTALLATION Ensure that: Ensure that: the oven cavity is square and level based on the required dimensions the oven door can open fully without obstruction the installation will comply with all clearance requirements and applicable standards and the oven is not sealed into the cabinetry with silicone or glue. -
Page 4: Standard Accessory Kit
COMPONENTS STANDARD ACCESSORY KIT INSTALLATION KIT Part No. 580720 Supplied with all models. Supplied with all models. Roast dish Grid Grill rack Food probe Screws (2) Cabinetry trim (1) Full extension sliding shelf Step down wire shelf STEAM ACCESSORY KIT Part No. -
Page 5: Product Dimensions
PRODUCT DIMENSIONS FRONT PROFILE OS60SDT PRODUCT DIMENSIONS A Overall height of oven B Overall width of oven C Overall depth of oven (excluding handle and dials) D Height of chassis E Width of chassis F Depth of chassis G Depth of oven frame and control panel (between front of chassis and front of oven door) H Depth of oven door when fully open (measured from front of control panel) PLAN... -
Page 6: Cabinetry Dimensions
CABINETRY DIMENSIONS PROUD INSTALL 16-20mm PROFILE PLAN FLUSH INSTALL OS60SDT 16-20mm CABINETRY DIMENSIONS A Minimum inside width of cavity B Overall width of cabinetry C Minimum inside height of cavity D Overall height of cabinetry E Minimum inside depth of cavity If installing a cooktop above the oven, ensure adequate clearance is provided as per the cooktop manufacturer’s instructions. - Page 7 DISCARD PACKAGING RESPONSIBLY Remove the packaging from the side and accessories box from the top of the oven, and set aside. Recycle responsibly...
- Page 8 CONNECT THE OVEN TO THE MAINS SUPPLY This oven must be connected to the mains power supply only by a suitably qualified person. Ensure cable This oven must be earthed. clamp is tightened Before connecting the oven to the mains power supply, check that: the domestic wiring system is suitable for the power drawn by the oven (as specified on the rating plate).
-
Page 9: Secure The Oven To The Cabinetry
SECURE THE OVEN TO THE CABINETRY cavity Do not lift the oven by the door handle. Do not over-tighten the screws. Do not seal the oven into the cabinetry with silicone or glue. This makes future For dark cabinetry, the supplied trim can be used to servicing difficult. -
Page 10: Installer Checklist
INSTALLER CHECKLIST TO BE COMPLETED BY THE INSTALLER TEST OPERATION: Ensure the oven is level and securely fitted to the cabinetry. Turn on the oven. The display should light up. Open the oven door slowly until it is fully open and check there is adequate Set the clock following the instructions in the ‘User guide’. - Page 12 FISHERPAYKEL.COM © Fisher & Paykel Appliances 2023. All rights reserved. The models shown in this guide may not be available in all markets and are subject to change at any time. The product specifications in this guide apply to the specific products and models described at the date of issue.