Fisher & Paykel 7 Series User Manual page 34

Operating problems
PROBLEM
Too much or too little
water when filling
Wash water
temperature is
not warm
Too many soap suds
Your washer is
making noises
Small puddle
coming from under
the washer
Odour coming from
Auto Dose dispenser
34
TROUBLESHOOTING
POSSIBLE CAUSES
Machine has been set to a Manual
Water level rather than Auto.
Your washer has been designed
to automatically sense load size
and minimise water use, therefore
the water level may look different
to your previous washer.
The unique high efficiency wash
system used 2 wash phases on
the , ,
COTTON ECO HIGH, FAST
cycle. The second phase will be
cooler than the first to minimise
energy use.
If is selected the wash
ECO
temperature will be cooler to
save energy during the wash
cycle.
Pre wash may have been
selected. A short, cooler wash will
be performed before the main
wash cycle starts.
Incorrect detergent being used.
Load is out of balance.
There is a fault indicated by
continuous beeping or a series
of beeps.
A dispenser may be blocked.
has not been
AUTO DOSE
used for a long time. Residue
remaining creating odour.
WHAT TO DO
Ensure Auto Water Level is set rather than
setting the water level yourself.
This is normal and will not affect wash
performance.
Allow cycle to complete.
Ensure you are using a Low Suds detergent.
Try using a little less detergent, especially if
garments are only lightly soiled.
Press and redistribute the load.
Refer to 'Fault codes'.
Refer to 'Care and Cleaning'.
Wipe the inside of the Auto Dose dispenser
cover. Run an Auto Dose Tank Clean cycle.
Refer to 'Care and Cleaning'.