Table of Contents
Advertisement
This message is for the use case where IP address blocking.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - IMM Network event
SNMP Trap ID: 37
CIM Prefix: IMM CIM ID: 0250
User Action:
Information only; no action is required
• FQXSPOS4000I: OS Watchdog response [arg1] by [arg2] .
This message is for the use case where an OS Watchdog has been enabled or disabled by a user.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0012
User Action:
Information only; no action is required
• FQXSPOS4001I: Watchdog [arg1] Screen Capture Occurred .
This message is for the use case where an operating system error has occurred and the screen was
captured.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0028
User Action:
If there was no operating-system error, complete the following steps until the problem is solved:
1. Reconfigure the watchdog timer to a higher value.
2. Make sure that the IMM Ethernet-over-USB interface is enabled.
3. Reinstall the RNDIS or cdc_ether device driver for the operating system.
4. Disable the watchdog.
5. If there was an operating-system error, check the integrity of the installed operating system.
• FQXSPOS4002I: Watchdog [arg1] Failed to Capture Screen.
This message is for the use case where an operating system error has occurred and the screen capture
failed.
Severity: Error
Serviceable: No
Automatically notify Support: No
Alert Category: System - other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0029
.
Chapter 2
XClarity Controller events
73
Advertisement
Table of Contents
