Lenovo ThinkSystem SR670 Reference Manual page 164

2. Resolve DIMM configuration so that the DCPMM ratio meets firmware requirements, then reboot the
system.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFMA0042K: Intel Optane DCPMM is not supported by processor of this system.
Severity: Error
User Action:
Validate system's memory configuration by using the memory configuration tool below: https://dcsc.
lenovo.com/#/memory_configuration.
• FQXSFMA0047M: SPD CRC checking failed on DIMM [arg1]. [arg2]
Severity: Warning
User Action:
Complete the following steps:
1. Perform a virtual reseat or AC cycle the server.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFMA0052I: DIMM [arg1] has been disabled due to the error on DIMM [arg2].[arg3]
Severity: Info
User Action:
Complete the following steps:
1. Power off the system and remove A/C power.
2. Reseat the DIMM in the slot specified by the event message.
3. Restore A/C power and power on the system.
4. If the problem persists, collect Service Data logs and contact Lenovo Support.
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFMA0065I: Multi-bit CE of DIMM [arg1] has been deasserted after performing post package
repair. DIMM identifier is [arg2].
Severity: Info
User Action:
Information only; no action is required.
• FQXSFMA0076M: DIMM [arg1] is not supported, DIMM identifier is [arg2].
Severity: Warning
User Action:
Complete the following steps:
1. Power off the system and remove A/C power.
2. Check user manual for supported DIMM types and replace the DIMM specified by the message with
a supported one.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
160
ThinkSystem SR670 Messages and Codes Reference