Table of Contents
Advertisement
Disassembly
6. Gently pull the two release latches (
Figure 6
arrows
RAM Module
7. Pull the latches to release the second module if necessary.
Removal (cont'd)
8. Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.
9. The module will only fit one way as defined by its pin alignment. Make sure the module is seated as far into the slot
c. Pull the release lat-
as it will go. DO NOT FORCE IT; it should fit without much pressure.
ches.
10. Press the module in and down towards the mainboard until the slot levers click into place to secure the module.
d. Remove the module.
e. Replace bay cover.
11. Replace the bay cover
down the bay cover).
12. Restart the computer to allow the BIOS to register the new memory configuration as it starts up.
Contact Warning
Be careful not to touch
the metal pins on the
module's
connecting
edge. Even the cleanest
hands have oils which
can
attract
particles,
and degrade the mod-
ule's performance.
11. RAM
2 - 10 Removing the System Memory (RAM)
&
9
(Figure
6c). The RAM module
11
(
Figure 6e
)
and the screws (make sure you reconnect the fan cable before screwing
c.
9
10
e.
) on the sides of the memory socket in the direction indicated by the
10
will pop-up
(
Figure 6d
)
, and you can then remove it
d.
11
Cover Pins
Note that this computer model has four
cover pins. These pins need to be aligned
with slots in the case to insure a proper cov-
er fit, before screwing down the bay cover.
.
Advertisement
Table of Contents
