Table of Contents
Advertisement
Service and maintenance
10.2 Checking and changing lubricants
10.2.5.4
Filling in oil
NOTICE
Mixing of different oils impairs the lubricity
When adding oil, use the same oil type and viscosity. If changing mutually incompatible oils,
see Flushing the gearbox (Page 59).
Observe the symbols in the diagrams of the Mounting positions and oil quantities (Page 76):
Venting
Procedure
1. Unscrew the vent plug.
2. Fill the gearbox with fresh oil. Use a filler filter with mesh of max. 25 μm.
3. Check the oil level.
4. Correct the oil level if necessary and check it again.
5. Check the state of the sealing ring on the sealing element. If the sealing ring is damaged,
replace the sealing element with a new one.
6. After filling with oil, seal the gearbox immediately using the sealing element.
You have now filled up the gearbox with oil.
10.2.6
Topping up with oil
If the mounting position of the gearbox is changed or oil lost because of leakage, check the oil
level. If you notice oil escaping, locate the leak, and seal the affected area. Top up and check the
oil level.
At the time of going to print, the following types of oil are being used when the gearbox is
filled for the first time:
CLP ISO VG220: Fuchs Renolin CLP220
CLP ISO PG VG220: Fuchs Renolin PG220
CLP ISO PG VG460: Fuchs Renolin PG460
CLP ISO PAO VG68: Fuchs Renolin Unisyn XT68
CLP ISO PAO VG220: Fuchs Renolin Unisyn XT220
CLP ISO PAO VG460: Fuchs Renolin Unisyn CLP460
CLP ISO E VG220: Fuchs Plantogear S220
CLP ISO H1 VG100: Klüber Klübersynth UH1 6 100
60
Operating Instructions, 01/2024, A5E53220855A/RS-AA
SIMOGEAR electric monorail gearbox
Advertisement
Table of Contents
