Pioneer SX-P920 Operating Instructions Manual page 77

Stereo receiver ampli-syntoniseur stereo / sound field processor processeur de champ sonore / sound image controller controle de relief sonore /stereo double cassette deck double platine cassette stereo /speaker system systeme d'enceintes
Table of Contents

Advertisement

TROUBLESHOOTING
Symptom
Cause
Remedy
RADIO BROADCAST
Broadcasts are in-
audible or hard to
hear.
The antenna isn't connected.
The antenna's orientation is incorrect.
You are using other electrical appli-
ances
(fluorescent lamps, dryer, etc.).
e
Connect an antenna correctly.
e
Adjust the direction of the antenna.
e
Stop using the appliances causing the
interference.
The broadcast is in
stereo, but the
receiver plays it in
mono.
The MONO
indicator is lighted in the
receiver's display.
e
Use the remote control unit to press
the FM MONO/RANDOM
button so that
the MONO
indicator goes out.
OTHER
The timer doesn't
operate.
The current clock time hasn't been set.
e
Set the current time properly.
The remote control
unit doesn't work.
The remote control unit's batteries are
dead.
A fluorescent lamp is shining too close
to the remote signal receiver.
®
Insert new
batteries.
@
Move the fluorescent lamp away.
The sound field
processor (sound
image controller)
doesn't work.
The EFFECT ON/OFF button has been
set to OFF.
¢
Press the EFFECT ON/OFF button to
ON.
When using the
vocal cancel func-
tion with micro-
phone mixing,
distorted sound is
recorded.
Play stops immedi-
ately after play/
pause button
(> /HH) is pressed.
No sound.
The cassette deck's APSC button is set
to ON.
COMPACT DISC PLAYER (PD-P720T, PD-P920M)
Ee
ee
The disc has been loaded upside down.
Player is in pause mode.
The stereo receiver is not being operat-
ed correctly.
Sound is distorted,
or noise is
produced.
Interference is being received from a
nearby television set.
>———_----_—__——-_-
oo
'"'"_v1;'1CVVvOo>—aeamama>anasas
e
Set the APSC button to OFF.
e@
Load the disc correctly with label side
up (PD-P720T).
e
Load the disc correctly with label side
down (PD-P920M).
e
Press play/pause button (P/8M).
e
Check the settings of the receiver's in-
put selector and VOLUME
controls.
°
Turn off the television, or move the
television farther away from the CD
player.
During playback
the playback
pauses or stops.
The disc has dirt or smudges on it.
©
Clean the disc.
A great deal of
noise is produced
when playing a
certain CD, or the
playback is inter-
rupted and
stopped.
The disc has a large scratch or warp.
The disc is severely soiled.
©
Replace the disc.
®
Clean the disc.
77
<ARE1211>
En

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents