KTM 150 XC-W 2018 Owner's Manual page 131

Info
Drain the gear oil while the engine is at operating temperature.
E00368-10
K00530-10
18 SERVICE WORK ON THE ENGINE
Preparatory work
–
Park the motorcycle on a level surface.
–
Place a suitable container under the engine.
Main work
–
Remove gear oil drain plug
–
Remove gear oil drain plug
–
Let the gear oil drain fully.
–
Thoroughly clean the gear oil drain plug.
–
Clean the sealing surface on the engine.
–
Mount and tighten gear oil drain plug
a new seal ring.
Guideline
Gear oil drain
plug with magnet
(125 XC‑W EU)
Gear oil drain
plug with magnet
(150 XC‑W US)
–
Mount and tighten gear oil drain plug
Guideline
Gear oil drain plug
(125 XC‑W EU)
Gear oil drain plug
(150 XC‑W US)
–
Remove filler plug 3 and fill up with gear oil.
Gear oil
–
Mount and tighten the oil filler plug.
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use an effective exhaust extraction system when
starting or running the engine in an enclosed
space.
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the gear oil level. (
1
with magnet.
2
.
1
with the magnet and
M12x1.5 20 Nm (14.8 lbf ft)
M12x1.5 20 Nm (14.8 lbf ft)
2
with a new seal ring.
M10x1 15 Nm (11.1 lbf ft)
M10x1 15 Nm (11.1 lbf ft)
0.80 l Engine oil
(0.85 qt.) (15W/50)
( p. 151)
p. 128)
129