SET UP & USE
OPERATION INSTRUCTIONS
COOL OPERATION
•
Press the "MODE" button until the
"COOL" indicator light comes on
•
Press the ADJUST buttons "
"
" to select your desired room
temperature. The temperature
can be set within a range of
62°F-88°F/17°C-30°C.
•
Press the "SPEED" button to choose
the fan speed.
HEAT OPERATION
(Applicable to the models with heat
feature only)
•
Press the "MODE" button until the
"HEAT" indicator light comes on
•
Press the ADJUST buttons "
"
" to select your desired room
temperature. The temperature can
be set within a range of 62°F-88°F
/17°C-30°C.
DEHUM OPERATION
•
Press the "MODE" button until the
"DEHUM" indicator light comes on.
•
Under this mode, you cannot select a
fan speed or adjust the temperature.
The fan motor operates at LOW
speed.
•
Keep window and door closed for
the best dehumidifying effect.
•
Exhaust hose attachment is not
required in this mode.
•
WATER FULL - When the water
level reaches a predetermined level,
the "water full" indicator light goes
on. The unit will have to be drained.
NOTE: · Refer to Water Drainage
section page 16.
FAN OPERATION
•
Press the "MODE" button until the
"FAN" indicator light comes on.
" or
•
Press the HIGH or LOW SPEED
button to choose the fan speed. The
temperature cannot be adjusted.
•
Exhaust hose attachment is not
required in this mode.
LED DISPLAY
Displays the set temperature in Celsius
or Fahrenheit. Displays Auto-timer
settings and while in DEHUM and FAN
modes displays room temperature.
Error codes and protection code:
E0: · Room temperature sensors error - Unplug
the unit and plug it back in. If error repeats, call
" or
for service.
E2: · Bottom tray is full - Connect the drain
hose and drain the collected water away. if
error repeats, call for service
TIMER OPERATION
•
When the unit is ON, first press the
TIMER button, the TIMER indicator
light illuminates. It indicates the
AUTO STOP program is initiated.
•
When the unit is OFF, first press the
TIMER button, the TIMER indicator
light illuminates. It indicates the
AUTO START program is initiated.
•
Continue to press the UP or DOWN
button to change the AUTO TIME by
1 hour increments, up to 24 hours.
The LED Display will indicate the
remaining time.
•
Turning the unit ON or OFF at any
time or adjusting the timer setting
to 00 will cancel the AUTO START/
STOP timed program.
Page 15