commercial cool CCPACA10 Series User Manual page 11

SET UP & USE
EXHAUST HOSE CONNECTORS
The exhaust hose and hose connectors must be installed or removed in accordance
with the usage mode:
COOL, AUTO : Install
FAN, DEHUMIDIFY, HEAT (ELECTRICAL) : Remove
1. Install the hose connector over the air exhaust discharge vent by inserting the left
side of the hose connector into the slots and then inserting the right side into the
grooves. Push down to lock into place.
2. Push the exhaust hose into the hose connector as shown.
3. Insert the opposite end of the exhaust hose into the window panel hose
connector.
NOTE: · The exhaust hose can be compressed or extended moderately, but it is desirable to keep
the length to minimum. Also make sure that the hose does not have any sharp bends.
PUSH DOWN
TO LOCK
If difficulty occurs, compress hose ends & thread into connectors.
INSERT
PUSH IN
Page 11