Bosch Professional GOP 18V-34 Original Instructions Manual page 23

Accessory
AIZ 28 SC
Starlock
28 × 40 mm HCS
universal joint cut-
ter
ASZ 32 SC
Starlock
24 mm wide HCS
pull cutting edge,
11 mm wide HCS
push cutting edge
ATZ 52 SC
Starlock
52 mm scraper, ri-
gid
Fitting/changing the accessory
Remove the accessory if one has already been fitted.
To do so, open the Starlock lever (7) all the way. The access-
ory will be ejected.
Position the required accessory (e.g. plunge cut saw blade
(12)) on the tool holder (8) so that the depressed centre is
facing downwards (see figure on the graphics page, text on
the accessory should be legible from above).
When doing so, place the accessory in a position which is
convenient for the job at hand. Twelve positions offset by
30° are possible for this.
Press the accessory in the required position firmly onto the
clamping jaws of the tool holder until it locks automatically.
Selecting a sanding sheet
Different sanding sheets are available, depending on the material you are working with and the required surface removal rate:
Sanding sheet Material
– All wood and wood-based
materials (e.g. hardwood,
softwood, chipboard, con-
struction boards)
– Metal materials
– Paint
– Varnish
– Filler
– Bodyfiller
Bosch Power Tools
Material Application
Expansion joints, window Cutting soft materials;
putty, insulation materials example: Cutting silicone expansion joints or window
(rock wool) putty
Roofing felt, carpets, arti- Quick and precise cutting of soft material and flexible, ab-
ficial turf, cardboard, PVC rasive materials;
flooring Example: Cutting carpets, cardboard, PVC flooring, re-
cesses in roofing felt
Carpets, mortar, con- Scraping on a hard substrate;
crete, tile adhesive Example: Removing mortar, tile adhesive and concrete
and carpet adhesive residues;
available as flexible scraper ATZ 52 SFC (soft carpet ad-
hesive/paint residues)
Check that the accessory is seated securely. Accessor-
u
ies that are attached incorrectly or are not securely fixed
in place may come loose during operation, thereby put-
ting you at risk.
Mounting and adjusting the depth stop
The depth stop (10) can be used when working with seg-
ment and plunge cut saw blades.
Remove the accessory if one has already been fitted.
Slide the depth stop (10) into the required working position
over the tool holder (8) and onto the collar of the power tool
as far as it will go. Allow the depth stop to engage. Twelve
positions offset by 30° are possible for this.
Set the depth you wish to work at. Push the clamping lever
(11) of the depth stop shut to fix the depth stop in position.
Application
For pre-sanding, e.g. of rough and uneven beams and
boards
For surface sanding and levelling of slight irregularities
For finish-sanding and fine sanding of wood
For sanding down paint
For sanding undercoats (e.g. removing brushstrokes,
paint drips and paint runs)
For final sanding of primers prior to painting
English | 23
Grit
Coarse 40
60
Medium 80
100
120
Fine 180
240
320
400
Coarse 40
60
Medium 80
100
120
Fine 180
240
320
400
1 609 92A 8RD | (07.08.2023)